DevFeeFinder
TransportationSet by regional JPA fee

SPRTA Tier 2 Fee

Levied by South Placer Regional Transportation Authority on new development in Lincoln.

What one house pays

$8,821

This fee is not in Lincoln's published figure. This site publishes a home outside any plan area, and this charge applies only in SPRTA Tier 2 area (V1-7, SUD A-C, Lincoln 270 and future annexed areas). The amount shown is what it costs a house that is there.

Total one-time fees here
$69,143
Adjustment
Adjusts yearly · ENR construction cost index
what the document says

annual, Engineering News-Record Construction Cost Index -- the average of the "20 Cities" and "San Francisco" series, March to March -- as a factor adopted by the SPRTA Board each spring; the 2026 factor is 1.01548 (1.548%)

Next expected change
1 Jul 2027

The record

We haven’t read the documents behind this fee yet, so this section is blank rather than guessed.

1,041 of 1,321 fees carry a quoted record; the largest were read first.

Every published rate

Every rate below applies to single-family detached.

RateBasisEffectiveAmount
SPRTA Tier 2 area (V1-7, SUD A-C, Lincoln 270 and future annexed areas)
per DUE 1 Jul 2026 $8,821
the line this rate was read from

“Tier 2 SPRTA Fees - R 210 Single Family | DU | DUE per Unit 1.00 | Fee per Unit $8,821 - EFFECTIVE: 7/1/2026”

South Placer Regional Transportation Authority, SPRTA Tier 2 Fee Schedule, updated 2026-03-09, effective 2026-07-01, p. 2 · source document ↗

About these figures

Quoted, not summarized. Every amount and fact on this page is copied from the official document it links to. If we couldn’t find something in a document, we leave it blank instead of guessing.

Before any discounts. Some fees offer credits, waivers or phase-ins. They’re listed above but not subtracted, because whether you qualify depends on your project.

Check the date. Fees change. This page shows what was in force on the date at the top, with a link to the document that set it, so you can confirm the current amount yourself. How all of this is put together.

↑↓ navigate↵ openesc close